Where To Start Shingling A Hip Roof

Make sure that you start with the first ridge cap lying on the bottom of the ridge of your hip roof.

Where to start shingling a hip roof.

You will also want to place them on top and do your best to center them on a seam between two on the previous row. Install the flashing on the ridges and tin strips along the edges of the hip roof to provide additional protection against water damage. Start by overlapping a starter from both sides of the valley at the bottom. The next one goes on the low side.

Then your first shingle goes on the side you are going to cut. The starting shingles for each row will typically be halved at the ridge of the hip roof as you ascend. Start at one edge of the roof and install the first row of cedar or asphalt shingles. A couple of weeks ago we published a two part series showing how a local roofing contractor shingled a roof with architectural shingles.

You can position them starting at the bottom or at the edges. After that line the shingle up with the roof and drive two nails through the top corners and one in the center to fasten it in place. Using a utility knife trim the right or left sides of your shingle depending on the end you started at so that it fits the angle of the roof. Install cedar shingles with two 5 penny.

You want to lay the shingles from the bottom to the top of the valley. Weave and cut the valley on the highest side of the roof. As you place each new row make sure the center of the next shingle up overlaps the previous row by 2 3 of the total length. This project guide is a combination of those two articles and it covers replacing the existing roof decking installing underlayment and ice dam protection laying the first row laying shingles in the field flashing ridge shingles and vents and more.

The lower edges of the shingles align with the lower edge of the roof. Unroll the felt so that the lines are facing upward. Working on the base of the edges of your hip roof by making use of 2 stacked shingles. Start nailing the shingles on the topmost corners.

Then trim the sides using a utility knife to match the angles. Now use a single cap at every spot as you go up the ridge. You need to trim those shingles so that they fit correctly. Step 2 line up the first shingle with the bottom of the entire shingle lined up with the bottom edge of the roof.